ideabehindit
Electricity and energy

V = IR: series and parallel resistors

Voltage pushes, resistance holds back, and current is what flows. Ohm's law ties the three together: V = I × R. Move the sliders to change the battery and the two resistors, and watch the charges speed up or slow down.

The idea behind it

Think of water in pipes. Voltage (V, in volts) is the pressure from the pump. Current (I, in amperes) is how much water flows each second. Resistance (R, in ohms, Ω) is how narrow the pipe is. More pressure gives more flow; a narrower pipe gives less.

So I = V ÷ R. With 6 V across 3 Ω, 2 A flows. Double the resistance and the current halves.

Series and parallel

SeriesParallel
Paths for currentOneOne for each resistor
CurrentSame through eachSplits; adds up to the total
VoltageShared between themFull voltage across each
Total resistanceR1 + R21 ÷ (1/R1 + 1/R2), smaller than either

The wiring in your home is in parallel: every light and socket gets the full 230 V, and switching one off does not affect the others.

In more detail

Ohm's law explains everyday things too. A heater has a low resistance so a large current flows and makes heat; a phone charger cable is thick so its resistance stays low and it does not warm up. Power, the energy used each second, is voltage times current (P = V × I), so a 230 V kettle drawing about 9 A uses roughly 2,000 watts. Fuses and circuit breakers protect wiring by cutting the circuit if the current gets too high, for example when a fault makes the resistance drop close to zero.